Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void
Relay control of 220v 150w fan - General Electronics - Arduino Forum
Controlling Any Device Using a Raspberry Pi and a Relay Module : 6 Steps ( with Pictures) - Instructables
220V safety control using relay module - General Electronics - Arduino Forum
Noise from 5v relay - General Electronics - Arduino Forum
Connect a 12V/220V Relay to Arduino - Motors, Mechanics, Power and CNC - Arduino Forum
Buy Relay module 1 channel with optoisolation - Botland - Robotic Shop
Advice on 220V kiln control safety - General Electronics - Arduino Forum
Controlling AC Devices with Arduino - SAFELY
Safety check of 230V relay project - #18 by Qdeathstar - General Electronics - Arduino Forum
I have a relay board but I dont know if it has optocoupler built in? - Motors, Mechanics, Power and CNC - Arduino Forum
Buy Relay module 4 channels with optoisolation - Botland - Robotic Shop
Remote light switch - relay and wall switch - Project Guidance - Arduino Forum
Relay stopped working after connecting lamp to it - Motors, Mechanics, Power and CNC - Arduino Forum
